MSA V-TEC io1 Instrucciones De Uso página 9

US
(1) Disconnect power from the PIT electrical system.
(2) Remove the access panel(s) over the control area. Find the open power receptacle
and clean as needed.
NOTE: Wipe away dust and dirt from the electrical leads with degreaser and a cloth.
Inspect the surface for visible dirt or corrosion that may impede electrical contact.
(3) Plug the input end of the power cord into the available power source. The red-striped
wire of the power cord is positive (+) and must be hardwired to a power source of 12-
24V. Use any leftover cable clips and cable ties to manage access wires.
a) Confirm the supplied io1 power connector will mate with the power receptacle.
Each PIT manufacturer has a slightly different preferred location. If unsure where
to connect to a hardwired power source on your truck, contact your local PIT
authorized service center.
b) Ensure the connector is fully connected and that there are no loose wires.
(4) Clean the area of attachment for the auxiliary power pack. This should be a flat
location on the control wall where the auxiliary battery pack will fit.
(5) Mount the combined 24V to USB converter and power pack module to the face of
the control wall using the peel and stick foam panel.
Apply pressure to ensure a good adhesion is made. Use zip-ties to add physical
restraint, if possible and placement permits.
NOTE: Confirm this location has the required clearance between the control wall
and the panel that will be placed over it.
(6) Mount the V-TEC io1 system onto overhead fall protection rail.
NOTE: Do NOT permanently fix the carabiner in place. It must be able to slide
freely.
(7) Locate a place for the charging line holder on one of the overhead vertical slats that
allows the charging line to hang freely.
4 Installation
9