Inspection; Troubleshooting - MSA V-TEC io1 Instrucciones De Uso

6 Inspection

6 Inspection
Inspection Component
io1 case
Alarm sounding hole
Charging line
Labels
See MSA V-TEC PFL Manual, MSA P/N 63011-96 (included in box) for Retractable Lanyard portion.
7

Troubleshooting

If the io1 is not working, perform a hard reset. See
Press the reset button on the side of the io1 plastic housing with a small paperclip to turn it off. Do this again to turn the io1
back on.
Figure 4 Reset io1
14
Inspect For:
Inspect for cracks, dents, and chipping.
Inspect for debris blocking alarm hole (remove if present). Confirm alarm sounds according to
status indicators in Table 1
Inspect charging line and verify they are free of any cuts or abrasions. The cables should be
fully secured at the each connection point and there should be no loose portions of wire.
Inspect labels to ensure they are present and all information is legible. The labels should be free
from abrasions or peeling.
Table 1
.
for status indicators.
US