US
5.1.2 Sleep Mode
When the io1 does not detect motion, the device enters sleep mode.
The io1 "wakes up" when it detects motion.
5.1.3 Battery Service Life
When the battery has 20% service life remaining, the io1 pulses red at 3 second intervals until it is plugged in to charge.
5.1.4 Charging the io1
5.2
Status Indicators
Table 1 Status Indicators
Hook Behavior
Initial Turn On/Reset
Ascending tri-tone followed by visual self
test of each LED light
While in Use
Sequence of ascending tones
Ascending single tri-beep tone
Pulsing red LED light
Intermittent pulsing green LED light
Pulsing red LED light while connected
Sequence of descending tones
Descending tri-tone and solid red LED
light
While Charging
Solid red LED light
Solid green LED light
WARNING!
Do NOT interfere with or obstruct the alarm lights and sounds.
Failure to follow this warning can result in serious personal injury or death.
(1)
Park the order picker truck.
(2)
Insert the charging cable into the USB-C port on the io1.
(3)
The LED is red if the battery is less than 90% charged. The LED is green if the
battery is at least 90% charged.
When the battery is fully charged, the LED pulses green.
Occurs When
io1 is turned on or reset with the reset button.
io1 wakes from sleep mode
io1 connects with harness tag
io1 is disconnected
io1 is connected
io1 battery is at 25% or lower
io1 wakes from sleep mode with a battery at 25% or lower
io1 is malfunctioning—See
io1 battery is less than 90% charged
io1 battery is at least 90% charged
"Troubleshooting"
for io1 reset information.
5 Operation
13