arjo Enterprise ENT-ACC66 Instrucciones De Uso página 3

Model ENT-ACC66 is designed to fill the gap between the foot end panel and foot end safety
sides (¾ folding safety sides or split safety sides). It is suitable for use with standard length
(235cm) and extended length (247cm) Enterprise
E9000X.
All references to the left or right of the bed are when viewed from the head end (i.e. by a patient
lying on the bed).
Refer to the bed user manual to confirm compatibility before use.
If a serious incident occurs in relation to this medical device, affecting the user, or
the patient then the user or patient should report the serious incident to the
medical device manufacturer or the distributor. In the European Union, the user
should also report the serious incident to the Competent Authority in the member
state where they are located.
Installation
The foot end infill panel accessory is supplied as a kit: foot end panel (A), left side panel (B) and
right side panel (C). Install the foot end infill panels as follows:
1. Remove bed frame footboard.
2. Fit the foot end infill panel (A) first, the brackets (2) fit over the mattress platform (3).
Make sure that the indexing plungers (5) mounted on the foot end panel (A), are located
beneath the mattress platform (3) and lock the end panel in position.
3. Pull the indexing plungers out (4) and install the left (B) and right (C) side panels, the
bracket (1) fits over the mattress platform (3). Secure the side panels in place by pressing
the indexing plungers in (making sure it is located into the hole of the foot end panel A).
C
4
4. Reinstall the bed frame footboard.
5. Check that the foot end panel and foot end safety sides are securely attached.
® series beds Enterprise E5000X, E8000X and
WARNING
A
2
3
5
4
1
EN
B