Operating The Remote Controller; Automatic Operation - Hiyasu ASE7U-RC Manual Del Usuario

Operating the Remote Controller

Install/Replace Batteries
The Remote Controller uses two alkaline dry batteries(LR03X2).
1. To install the batteries, slide the back cover of the battery compartment and install the batteries according
the direction (+and -)shown on the Remote Controller.
2. To replace the old batteries, use the same method as mentioned above.
NOTE
1. When replacing batteries, do not use old batteries or a different type battery. This may cause the remote
control to malfunction.
2. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery leakage
may damage the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission
Indicator light fails to light.
5. Do not dispose batteries as unsorted municipal waste. Collection of such waste separately for special
treatment is necessary.

AUTOMATIC OPERATION

Switch on the power and the OPERATION indication lamp on the display panel of the indoor unit starts
flashing, and turns off after flashes for 6 times.
1. Use the MODE button to select AUTO.
2. Push the TEMP button to set the desired room temperature. The most comfortable temperature settings
are between 21ºC to 28ºC.
3. Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the display panel of the
indoor unit lights. The FAN SPEED is automatically set and there are no fan speed indicators shown on
the display panel of the remote controller.
4. Push the ON/OFF button again to stop the unit operation.
NOTE
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN and HEAT by
sensing the difference between the actual ambient room temperature and the set temperature on the
remote controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually.
COOL/ HEAT (Cooling only model without) and FAN Operation
1. If the AUTO mode is not comfortable, you may manually over-ride the settings by using COOL, HEAT or
FAN modes.
2. Push the TEMP button to set the desired room temperature. When in COOLING mode, the most
comfortable settings are 21ºC or above. When in HEATING mode, the most comfortable settings are
28ºC or below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button, the operation lamp lights and the air conditioner start to operate as your
settings. Push the ON/OFF button again to stop this unit operation.
NOTE
• The FAN mode can not be used to control the temperature. While in this mode, only steps,1 3 and 4 may
be performed.
DRY Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 21 C to 28 C.
3. Push the ON/OFF button, the OPERATION lamp lights and the air conditioner starts to operate in DRY
mode at LOW fan speed. Push the ON/OFF button again to stop this unit operation.
NOTE
Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air
Conditioner when in DRY mode will automatically operate many times without running the COOL and FAN
mode.
23