Beem Espresso-Classico Manual De Instrucciones página 26

EN
Never immerse the device and the connecting cable in water or
•
other liquids and ensure that these components cannot fall into
water or become wet.
The device must always be disconnected from the mains when it is
•
left unattended and before assembling, disassembling, fi lling or emp-
tying the water tank or milk tank or cleaning it.
Do not make any modifi cations to the device. Do not replace the
•
connecting cable yourself. If the device or the connecting cable of
the device are damaged, they must be replaced or repaired by the
manufacturer, customer service department or authorised distribu-
tors in order to avoid any hazards.
It is essential to follow the instructions in the "Cleaning and Care"
•
chapter.
DANGER – Danger of Electric Shock!
• Use the device only in closed rooms.
• Do not use the device in rooms with high humidity.
• If the device falls into water while it is connected to the mains power, switch off the power
supply immediately! Only after this should you pull the device out of the water.
• Never touch the device and the connecting cable with wet hands when it is connected to the
mains power.
• Make sure that the steam which emerges is not aimed directly at electrical devices and equip-
ment containing electrical components.
WARNING – Danger of Injury!
• Keep the packaging material away from children and animals. There is a danger of suffocation!
Danger of scalding from heat, hot steam or condensation!
• Avoid coming into contact with the rising steam. Keep your hands and head away from the
steam outlet openings during the brewing process.
• The portafi lter will become hot during use. Never attempt to remove the portafi lter dur-
ing the brewing process.
• Do not touch the milk nozzle after use.
07440_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 24 07440_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 24
24
21.06.2021 10:50:09 21.06.2021 10:50:09