Dry Operation - Hiyasu ASE 9U2i Manual De Funcionamiento

06Manual 10Hiyasu Eng 19/4/06

Dry Operation

(1) Unit start
Link with electronic power.
Press ON/OFF on the remote controller, unit starts.
The liquid crystal will display the working state of last time (Except Timer, Sleep,
Power/Soft and Health airflow).
2) Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Select DRY operation
Then
(3) Select temp.setting
Press TEMP. button
Every time the button is pressed, temp.setting increase 1ºC,if kept depressed,
it will increase rapidly
Every time the button is pressed, temp.setting increase 1ºC,if kept depressed,
it will decrease rapidly
Select a desired temperature.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Air conditioner is running under displayed fan speed
In DRY mode, when room temperature becomes 2ºC
higher than temp.setting,unit will run intermittently at
LOW speed regardless of FAN setting.
(5) Unit stop
Press ON/OFF button, the unit stops.
COOL operation starts when room
temp.is higher than temp.setting.
Temp.setting+2ºC
Temp.setting
86
13:11 Página 86
OPERATION
Ultra-low air flow
On reaching temp.setting +2ºC
unit will run in mild DRY mode.