Timer On/Off Operation; Time Setting - Hiyasu ASE 9U2i Manual De Funcionamiento

06Manual 10Hiyasu Eng 19/4/06

Timer On/Off Operation

Set clock correctly before starting TIMER operation.
(1) After unit starts, select your desired operation mode
Operation mode will be displayed on LCD.
(2) Timer mode selection
Press TIMER button to change TIMER mode. Every time
the button is pressed, display changes as follows:
Then select your desired TIMER mode (TIMER ON or TIMER OFF).
" " or " " will flash..

(3) Time setting

Press HOUR /
Every time the button is pressed, time setting increases 1 min , if kept depres-
sed, it will increase rapidly.
Every time the button is pressed, time setting decreases 1 min, if kept depres-
sed, it will decrease rapidly.
It can be adjusted within 24 hours.
(4) Confirming your setting
After setting correct time, press SET button to confirm "
remote controller stops flashing.
Time displayed: Unit starts or stops at x hour x min.
(TIMER ON or TIMER OFF).
(5) Cancel TIMER mode
Just press TIMER button several times until TIMER
mode disappears.
Hints:
After replacing batteries or a power failure happens, time setting should be
reset.
Remote controller possesses memory function, when use TIMER mode next
time,just press SET button after mode selecting if time setting is the same as
previous one.
13:11 Página 91
OPERATION
button.
" or " " on the
91