Sony ZS-2000 Manual De Instrucciones página 43

Symptom
The audio is weak or has poor
quality.
The audio is not stereo.
The picture of your TV becomes
unstable.
The station name does not appear in
the display though you are listening
to an FM programme.
The player cannot receive the clock
data signal. (" " does not flash and
flashes in the display.)
The timer does not operate.
The remote does not function.
The player uses a built-in micro computer for its various operations. Due to change in power
supply conditions, etc., operation may sometimes become unstable. After trying the above
remedies, if the player still does not function properly, unplug the mains lead. While keeping
SNOOZE and SUMMER pressed at the same time, plug the mains lead again. If the problem
persists, please consult your nearest Sony dealer.
Remedy
• Move the player away from the TV.
• If you are using the remote while listening to
MW/LW radio, noise may be heard. This is
unavoidable.
• Press PLAY MODE•MONO/ST on the player
until "STEREO" appears.
• If you are listening to an FM programme near
the TV with an indoor aerial, move the player
away from the TV.
• The RDS function of this player will not be
activated if the station you are tuning in does
not provide RDS services.
• Connect the cord of the aerial unit correctly
(page 34).
• Adjust the orientation of the aerial unit. If the
player still cannot receive the data signal, place
the aerial unit near the window.
• Make sure the time on the clock is correct.
• Check to see if the AC power had been cut off.
• Make sure the (clock) indication is displayed.
• Replace all the batteries in the remote with new
ones if they are weak.
• Make sure that you are pointing the remote at
the remote sensor on the player.
• Remove any obstacles in the path of the remote
and the player.
• Make sure the remote sensor is not exposed to
strong light such as direct sunlight or
fluorescent lamp light.
• Move closer to the player when using the
remote.
Additional Information
GB
43