Sony ZS-2000 Manual De Instrucciones página 31

Tips
• To exit the standby
mode, press STANDBY
to make the
indication disappear.
• The preset settings
remain until you reset
them.
4
Set the timer to the hour and the minutes you want
the music to go on.
1 Press TUNE•TIME
SET + or – to set the
hour and press
DISPLAY•ENTER
MEM.
2 Press TUNE•TIME SET + or – to set the minutes
and press DISPLAY•ENTER MEM.
5
Press TUNE•TIME SET + or – to set the volume
you want, and press DISPLAY•ENTER MEM.
6
Press STANDBY.
The indication lights up and the power goes off;
the player enters the standby mode.
At the preset time, the power will go on and music
will play. Then the power will go off after 1 hour,
and the player will enter the standby mode again.
To check/change the waking up timer settings
Press TIMER, then DISPLAY•ENTER MEM. Each
time you press DISPLAY•ENTER MEM, a stored
setting is displayed in the set order. To change the
setting, display the setting you want to change and
re-enter it.
To use the player before a timer playback starts
If you turn on the player, you can use it as usual (in
case of the radio, if you listen to the station which is
different from the one you tuned in step 1 on page 30,
you will hear that station at the preset time). Turn off
the player before the preset time.
continued
GB
31
The Timer