Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Warnings
The Manufacturer declines all responsibilities if the precautions below are not taken.
The accomplishments concerning working environment safety and health regulations indicated by the current
laws (Dir. 2003/10/EC, Dir. 2002/44/EC and Legislative Decree no. 81/2008) have to be carried out either by the
end-user or by the employer: supplying the adequate personal protective equipment, informing about working
risks, health surveillance, etc....
The over-exposure to the vibrations may cause neurovascular lesions to people suffering from circulatory dis-
orders. In case of symptoms which could be referred to over-exposure, contact a specialist. These symptoms
can be torpor, loss of sensitivity, sharp pains, itching, strength reduction or loss, complexion discoloration or
structural modifications of its surface. This usually happens to one's hands, wrists and fingers.
Results of the tests made according to the Laws
1) NOISE LEVEL
Continuous A-weighted sound pressure level at the operator's position (LpA) and sound power level
of the equipment (LwA), both measured according to Standard EN 3744: 2010
Measured sound power level: Lpa (dBa): 88 ± 1,8
Guaranteed sound power level: Lwa (dBa): 99,7 ± 1,8.
2) VIBRATION LEVEL
Root mean square weighted hand-arm acceleration frequency to which the user is exposed, measured
according to UNI EN ISO 20643.
Shear with 0.5 m fixed extension pole
Shear with 1.0 m fixed extension pole
Shear with 1.5 m fixed extension pole
Shear with 2.0 m fixed extension pole
Shear with 2.5 m fixed extension pole
Shear with 3.0 m fixed extension pole
Shear with 1,00 ÷ 1,50 telescopic extension pole
Shear with 1,50 ÷ 2,50 telescopic extension pole
Shear with 2,00 ÷ 3,00 telescopic extension pole
General warnings
Do not use the tool indoor or in case of potentially explosive environment.
•
The product is for a professional use only.
•
Use only with the accessories indicated by Campagnola s.r.l.
•
Use the tool only from the ground, working in a stable and safe position.
•
Always use adequate clothing as called for by the job. Wear protective goggles and verify that your clothes are fitting
to the body. Do not wear ties, necklaces or belts or keep loose long hair which may get caught in the moving parts.
Use anti-sliding shoes and protective gloves.
•
Wear a noise-abatement headset.
•
Do not operate, service or repair the tool if you are under the influence of medicines, alcohol or drugs which could
impair your alertness or co-ordination.
•
The tool can only be used by suitably trained and instructed operator through safety training.
•
The air compressor, to which the tool is connected, must comply with the current laws and be fitted with control
valves.
•
Entrust or lend the tool only to persons who are familiar with the instructions for use or trained by authorised persons.
•
Keep children and animals away from the tool.
•
Never alter the safety and protective devices.
•
The user is the responsible for dangers or injuries caused to other people or for damages caused to their properties.
•
Do not use the tool when you are in unstable position or off balance.
•
It is forbidden to operate the tool on ladders.
•
Never cut branches which are close to electric wires.
•
Before any routine maintenance operations, read the use and maintenance manual carefully. For any maintenance
operation which is not indicated in this manual, please contact one of the CAMPAGNOLA S.r.l. Authorised Service
Points.
Pag. 20
K (uncertainty value for all extension poles) = 0,71 m/s
a
= 8,47 m/s
2
heq
a
= 5,41 m/s
2
heq
a
= 4,33 m/s
2
heq
a
= 4,21 m/s
2
heq
a
= 4,06 m/s
2
heq
a
= 3,87 m/s
2
heq
a
= 4,03 m/s
2
heq
a
= 3,66 m/s
2
heq
a
= 3,46 m/s
2
heq
2
Use and maintenance manual – Translation of
original Instruction Rev.: 01, Date 10/11/2021
Publicidad
Capítulos
Tabla de contenido
