Symbols And Their Meaning - Bosch GCM 18V-305 GDC Professional Manual Original

Warning! If operating or adjustment devices other
u
than those specified here are used or other proced-
ures are carried out, this can lead to dangerous expos-
ure to radiation.
Do not replace the integrated laser with a laser of an-
u
other type. A laser that is not compatible with this power
tool could pose a risk to persons.
Caution! When using the power tool with Bluetooth
u
fault may occur in other devices and systems, aero-
planes and medical devices (e.g. pacemakers, hearing
aids). Also, damage to people and animals in the im-
mediate vicinity cannot be completely excluded. Do
not use the power tool with Bluetooth
medical devices, petrol stations, chemical plants,
areas with a potentially explosive atmosphere or in
blasting areas. Do not use the power tool with
®
Bluetooth in aircraft. Avoid using the product near
your body for extended periods.
The Bluetooth® word mark and logos are registered trade-
marks owned by Bluetooth SIG, Inc. and any use of such
marks by Robert Bosch Power Tools GmbH is under li-
cense.
Symbols
The following symbols may be important for the operation of
your power tool. Please take note of these symbols and their
meaning. Correctly interpreting the symbols will help you to
operate the power tool more effectively and safely.

Symbols and their Meaning

Laser radiation
IEC 60825-1:2014
<0.39mW, 650 nm
LASER RADIATION
DO NOT EXPOSE USERS OF
Do not view directly with telescopic
TELESCOPIC OPTICS
CLASS 1M LASER PRODUCT
optical probe
Laser class 1M
Keep hands away from the cutting area
while the power tool is running. Con-
tact with the saw blade can lead to injur-
ies.
Wear a dust mask.
Wear safety goggles.
Wear hearing protection. Exposure to
noise can cause hearing loss.
Bosch Power Tools
Symbols and their Meaning
®
, a
305 mm
Ø
®
in the vicinity of
Danger area! Keep hands, fingers and
arms away from this area.
Keep your fingers away from the mov-
ing parts of the glide arm. There is a risk
of fingers being crushed and severely in-
jured.
Take note of the dimensions of the saw
30
Ø
mm
blade. The hole diameter must fit the tool
spindle without play. If it is necessary to
use reducers, ensure that the dimensions
of the reducer are suitable for the base
blade thickness and the saw blade hole
diameter, as well as the tool spindle dia-
meter. Wherever possible, use the redu-
cers provided with the saw blade.
The saw blade diameter must match the
information specified on the symbol.
Shows the rotational direction of the SDS
bolt for tightening the saw blade (anti-
clockwise) and for loosening the saw
blade (clockwise).
When transporting the power tool, hold it
only at the locations indicated (recessed
handles) or by the transport handle.
Never carry the power tool using the
handle of the glide arm.
For bevel angles, you need to adjust the
left/right fence extension or completely
remove it.
In combination with the ProCORE-18V
rechargeable batteries, the new high-per-
formance motor offers a comparable per-
formance to that of the motors of corded
power tools.
Clamping handle open:
Bevel angles can be adjusted.
Clamping handle closed:
The set bevel angle of the glide arm is
locked.
Indicates the individual steps for adjust-
ing the bevel angle.
1. Loosen the clamping handle
2. Swivel the glide arm slightly to the left
1 609 92A 6TT | (19.07.2021)
English | 19