Connection To An Extension Pole; Control Devices; Starting The Tool; Stopping The Tool - CAMPAGNOLA Hercules Manual De Uso Y Mantenimiento

Connection to an extension pole

Assemble the tool onto an extension pole (11), insert the shaft and tighten the screws (5) of the clamp (3).

Control devices

All information can be found in the use and maintenance manual of the power unit.

Starting the tool

Before starting your task, wear adequate safety clothing (picture A) and check that all the safety devices are well assembled
and can operate properly.
WARNING!
• Operate the tool only when it is among the branches. Any improper use damages the tool and causes excessive
battery power consumption.
• Use the tool only for the purposes indicated in ch. "Product description". Any other kind of use may cause
injuries.
• All information about using and operating the tool can be found in the use and maintenance manual of the
chosen power unit.

Stopping the tool

The tool must always be switched off at the end of the work season. All information about using and operating the tool can
be found in the use and maintenance manual of the chosen power unit.

Troubleshooting

WARNING!
All the following special maintenance operations shall be carried out by a service mechanic.
FAULT
Mechanical head overheating
Anomalous rake (2) vibrations
The tool does not work
The tool is not powerful
enough
IMPORTANT:
If the above-mentioned remedies do not solve the problem, contact an Authorised Service Point

Improper uses

- Do not use the tool when you are in an unstable position or off balance.
- Do not use the tool as a lever or for lifting, moving or breaking any objects.
- Do not use the tool if the atmosphere is explosive or inflammable.

Tool transport

In case of long transports keep the tool in its packaging.
WARNING!
Use the tool only for the purposes indicated in ch. "Product description". Any other kind of use may cause injuries.
Page 18
CAUSE
Dirt and/or wear and tear of the inner rotating
parts.
• Rotating parts wear and tear.
• Wrong tightening of the rake fixing screws (6).
Flat battery
Flat battery
REMEDY
Carry out the mechanical head clean-
ing and maintenance operations.
• Carry out the mechanical head clean-
ing and maintenance operations.
• Tighten the screws (6).
Recharge the battery (read the power
unit manual).
Recharge the battery (read the power
unit manual).
Use and maintenance manual – Traslation of the
original Instructions Rev.: 00, Data 03/07/2020