Bosch EXACT Manual Original página 18

18 | English
Folder Installation path
Sets a different installation path
Browse
Disk Cost Storage requirements for
Bosch EXACT Configurator
Everyone Sets the user access to Bosch EX-
Just me ACT Configurator
– Select the required settings and click on Next.
The Confirm installation dialogue box is displayed.
The installation program is ready to commence installa-
tion.
– Click on Next to begin installation.
The Bosch EXACT Configurator program is installed
on the PC. Links to launch the program can then be found
in the Start menu and on the desktop.
– Click on Close to complete the installation.
1 609 92A 606 | (20.01.2021)
Connecting the Screwdriver with the PC
If Bosch EXACT Configurator is already open when con-
necting a (new) screwdriver, Windows will attempt to install
the relevant drivers. If this is the case, wait until the installa-
tion is complete. There is no need to restart the PC in this in-
stance.
– Connect the screwdriver using the Micro-USB connector
of the USB cable (see "System Requirements", page 17).
For the EXACT 12V, the USB port is located under the
cover. You will therefore need to unscrew the cover.
– Connect the PC (e.g. laptop) using the USB connector on
the USB cable (see "System Requirements", page 17).
Note: Depending on the operating system, a request to re-
start the computer may be displayed once the USB cable is
connected to the PC. However, this is not necessary for the
process to continue.
Bosch Power Tools