Bosch EXACT Manual Original página 29

Parameter
Phase Length Unit
Runtime
Rotation Angle at output
Bosch Power Tools
Description
The transition to the next step can be con-
trolled either by rotation angle or by time.
Depending on the setting, the following para-
meter is activated.
This parameter determines the time after which
the process transitions to the next step.
Note: If the set torque on the clutch is already
reached during the threading phase, the screw-
driver still switches off and signals an incorrect
thread assembly.
This parameter determines the angle at which
the process transitions to the next step. This
setting is dependent on the gear ratio in the
Identification Data tab.
A rotational angle setting is subject to toler-
ances and must be checked again outside of
the program.
Note: If the set torque on the clutch is already
reached during the threading phase, the screw-
driver still switches off and signals an incorrect
thread assembly.
English | 29
Value
Rotation angle
Transition is controlled by the rota-
tion angle
The Rotation Angle at output para-
meter is activated
Time
Transition is controlled by time
The Runtime parameter is activated
Clutch signal
Transition is completed after a
switch-off signal is emitted by the
shut-off clutch
Adjustable within the set limits
Adjustable within the set limits
1 609 92A 606 | (20.01.2021)