Bosch EXACT Manual Original página 30

30 | English
Messages
This table shows all the error messages that might appear
when working with Bosch EXACT Configurator.
Example:
Title
Question
Unwritten Changes
Reset Parameters
Unread Parameters
Unwritten Parameters
Invalid Checksum
Maximum Number of Transmis-
sions Has Been Reached
Unknown Message Received
1 609 92A 606 | (20.01.2021)
– Depending on the content of the message, confirm the
Message text
You are still connected to a screw-
driver, do you really want to exit?
Not all changes were transferred to
the device. Should they be written
now?
Do you really want to reset the current
settings?
The following parameters could not
be read:
The following parameters could not
be written:
Received a message with invalid
checksum value.
The retry counter of the service has
been reached, device will be discon-
nected.
Received an unknown message.
notifications, questions or warnings with a Yes or No.
Meaning
Confirmation is required to end the program
when a screwdriver is still connected.
When disconnecting the screwdriver, there are
still unwritten parameter changes.
Confirmation is required to reset to the default
data sets.
Bosch EXACT Configurator operating pro-
gram and the screwdriver firmware are not
compatible.
Screwdriver is faulty.
Bosch EXACT Configurator operating pro-
gram and the screwdriver firmware are not
compatible.
Screwdriver is faulty.
Communication error
Screwdriver is faulty.
Communication error
Screwdriver is faulty.
Bosch EXACT Configurator operating pro-
gram and the screwdriver firmware are not
compatible.
Screwdriver is faulty.
Bosch Power Tools