Working With Detergent; After Finishing Work; When Work Is Finished - Stihl RE 80.0 Manual De Instrucciones

English

10.4 Working with Detergent

Detergents can increase the cleaning effect of the water.
The supplied STIHL spraying set must be used.
► Dose and use detergent as described in the instructions
for use of the detergent.
► Fill the bottle (1) with maximum 500 ml of the detergent.
► Screw the spray nozzle (2) onto the bottle (1) and tighten
firmly by hand.
4
► If a nozzle is attached to the spray lance (3): Remove the
nozzle.
► Attach the spray set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water before cleaning
them.
► Press the spray gun lever and spray the detergent onto
the surface to be cleaned.
► Apply the detergent starting at the bottom and working up
and do not allow to dry.
60
2
1
3
► Remove the spraying set.
► Attach the nozzle.
► Clean the surface.

11 After Finishing Work

11.1 When Work is Finished

► Switch off the high-pressure washer and pull the mains
plug out of the socket.
► If the high-pressure washer is connected to the water
supply: Turn off water supply.
► Press the spray gun trigger.
The water pressure is reduced.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the water
source.
► Remove the water hose.
► Remove the high-pressure hose and let the rest of the
water run out of the high-pressure hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the rest of the water run out
of the spray gun.
► Clean the high-pressure washer.
11 After Finishing Work
0458-001-8721-A