Protecting The Pressure Washer With Antifreeze; Transporting; Transporting The High-Pressure Washer - Stihl RE 80.0 Manual De Instrucciones

12 Transporting

1
7
6
► Roll up the high-pressure hose (1) and hang it on the
holder (2).
► Coil the connecting cable (3) on the holder (2).
► Secure the connecting cable (3) using the clip (6).
► Insert spraying set (5).
► Insert the nozzles (7).
► Store the spray attachment in the holders (4) on the high-
pressure washer.
0458-001-8721-A

11.2 Protecting the pressure washer with antifreeze

If the pressure washer cannot be protected from frost during
2
transport or storage, the pressure washer should be
protected by a glycol-based antifreeze. The antifreeze
prevents water inside the pressure washer from freezing and
causing damage to the pressure washer.
► Remove spray lance
3
► Connect the shortest possible water hose to the pressure
washer.
The shorter the water hose, the less antifreeze is needed.
► Mix the antifreeze as described in the antifreeze
4
Instruction Manual.
► Pour antifreeze into a clean container.
5
► Insert water hose into container of antifreeze.
► Squeeze and hold spray gun trigger.
► Switch on pressure washer.
► Hold down spray gun trigger until an even jet of antifreeze
is delivered from the spray gun and point the spray gun
into the container.
► Press and release spray gun trigger several times.
► Switch off pressure washer and unplug mains plug from
the socket.
► Detach spray gun, high-pressure hose and water hose
and allow antifreeze to run into the container.
► Store and dispose of antifreeze in accordance with the
applicable regulations and in an environmentally
responsible manner.
12 Transporting

12.1 Transporting the high-pressure washer

► Switch off the high-pressure washer and pull the mains
plug out of the socket.
► Empty or secure the detergent container so that it cannot
topple over, fall down and cannot move.
English
61