Tool Change; Adjustment Operation; General Use Instructions; Maintenance And Cleaning Instructions - stayer LS1200 Manual De Instrucciones

- Loosen the screws with knurls 12 and remove both discs.
- Move the tool or the corresponding support over the tool
holder (position adjustment, key).

4.2. Tool Change

Gear.
Do not loosen the screws at the gear head (8)
during the guarantee period. Non-compliance
will lead to expiry of the manufacturer's

guarantee.

4.3. Adjustment Operation

Protection cover adjustment
The burnishing machine will always be used
with the protection cover in place (Fig. 5)
- 1. Loosen cover adjustment screw 3 (Fig. 5)
- 2.Adjust the protection cover in a position that is
appropriate for the task to be performed and in the
corresponding work position (Fig. 5)
- Adjust screw 3 once more.

4.4. General Use Instructions

Once turned off, the grinding tool continues
working briefly due to inertia.
Processing of flat surfaces (Fig. 6)
- Hold the electrical tool with both hands.
- For a decorative finishing of the surface:
- Carefully base the electrical tool on the surface to be
processed, performing a straight-line movement forward
and then back.

5. Maintenance and Cleaning Instructions

Disconnect the power supply plug before
performing any work in the electrical equipment.
Limpieza
Conducting dust may be deposited inside the
casing when processing metals.
This may have an influence on the protection
insulation!
Start the machine using a differential circuit breaker
(maximum operating current 30 mA)
Regularly clean the equipment and the ventilation slits.
Cleaning frequency will depend on the material and the
intensity of use.
Periodically clean the lower part of the casing and the
motor with dry compressed air.
ENGLISH
15

5.1 Repair Service

The technical service will advise you on any query you may
have regarding repairs and maintenance of your product,
while also on spare parts. The diagrams for taking apart
and the information on spare parts are available at:
info@grupostayer.com
Our team of technical advisors will be pleased to guide
you regarding the acquisition, application and adjustment
of the products and accessories.
5.2 Guarantee
Guarantee Card
You will find the guarantee card among the documents
included with the electrical tool. The guarantee card must
be filled in completely attaching to it a copy of the purchase
receipt or bill and handing it in to the retailer in exchange
for an acknowledgement of receipt.
NOTE! Request this card immediately from your retailer if
it is missing.
The guarantee is exclusively limited to manufacturing
or machining defects, expiring whenever the pieces are
disassembled, handled or repaired outside the factory.

5.3 Elimination

We recommend
packaging are subjected to a recycling process which
respects the environment.
Only for EU countries:
Do not throw electrical tools into the rubbish!
In accordance
2012/19/EU on waste electrical and electronic
equipment, after its transposition into a national
law, electrical tools will be accumulated
separately to be subjected to ecological recycling.
Right of modification reserved.
15
electrical tools, accessories
with European
and
Directive