Sending An Image Using E-Mail - Kyocera KM-6230 Manual De Instrucciones

(3) Sending an Image Using E-mail

E-mail lets you utilize the Scanner Delivery Utility to have scanned
image data prepared as a file attached to an email message and
then sent to a network computer or to any other computer over the
Internet.
* In order to use E-mail, the Scanner Delivery Utility must be installed
and running in a computer on your network.
* It is possible to register the destination computer in advance (for
more detailed information, refer to the On-Line Manual) or enter the
email address of the desired destination manually during the set-up
procedure.
Press the Copier/Printer/Scanner key. The basic scanning
1
screen will appear.
2
Touch the "Send E-mail" key.
* If the destination computer is registered in advance, touch
the "Select" key and proceed to the next step. If you want
to enter the email address of the desired destination
manually, touch the "Input" key and proceed to step 5.
3
Select the desired registration name (registered name of the
destination party). (Up to 10 names can be selected for a
single operation.)
* The registered names will be displayed in blocks of 10. If
you want to select a name other than those currently
displayed, touch the key on the touch panel that corre-
sponds to the block of ten numbers which contains that
name.
4
Touch the "Enter" key and proceed to step 8.
All manuals and user guides at all-guides.com
Section 3 Using the Scanner
5
Use the displayed keys to enter the desired destination
email address(es).
The "Back" key will return you to the screen for step 2.
The "Erase" key will delete the character to the left of the
cursor.
The "O" and "P" keys will move the cursor in the corre-
sponding direction.
6
Touch the "End" key.
7
A confirmation screen will appear. If the displayed informa-
tion is correct, touch the "OK" key and proceed to the next
step. If you want to re-register the address(es), touch the
"Redo" key. The displayed address(es) will be deleted and
the touch panel will return to the screen for step 5. Enter the
desired address(es).
8
Select your registered sender name. (If that name is not
displayed, touch the " " key or the " " key until it is
displayed.)
9
Touch the "Enter" key.
3-8