Setting The Scanner Address; Dhcp Setting; Changing The Management Pin Code For The Scanner - Kyocera KM-6230 Manual De Instrucciones

Section 3 Using the Scanner

Setting the Scanner Address

4
The currently registered IP address, subnet mask and
gateway address will all be displayed. If you want to change
one of these addresses, touch the appropriate "Change" key
to display the corresponding setting screen.
* If the DHCP setting is turned "On", you will not be able to
change these settings even by typing them in.
5 The address will be separated into four blocks of three
numbers each. Touch the "Enter #" key until the block to be
changed is highlighted and use the numeric keys to enter
the desired number for that block. Once the complete
address is entered as desired, touch the "End" key.
* The illustration in step 6 shows the screen used for
entering the IP address.
6
Touch the " " key to proceed to the next screen.
3-3
All manuals and user guides at all-guides.com

DHCP Setting

7 If you turn this setting "On", the IP address, subnet mask
and gateway address will all be configured automatically
from the DHCP server. To turn this function off, select "Off".
Touch the "-" or "+" key to select either "On" or "Off".

Changing the Management Pin Code for the Scanner

8
If you want to change the displayed management pin code
for the scanner, touch the "Change" key, use the numeric
keys to enter the desired 4-number management pin code
and then touch the "Change" key once again. The message
display will return to the off-line screen.
* It is recommended that you make some sort of notation of
the new code as, if it is forgotten, it will not be possible to
verify or make changes to the network default settings.
9
Once all desired changes to the network default settings are
complete, touch the "End" key. The touch panel will return to
the basic scanning screen.