When This Message Is Displayed - Kyocera KM-6230 Manual De Instrucciones

Section 2 Using the Printer

2-6 When This Message is Displayed...

If one of the following messages appears on the touch panel, verify the content of the message and perform the appropriate procedure. At the
same time, refer to the Instruction Handbook for your copier or the Instruction Handbook of any optional unit that may be installed, as appropriate.
Message
Warning Low memory
Memory overflow. Press "Continue" to
resume job.
Data overrun. Press "Continue" to resume
job.
Printer board error.
Printer board error.
EEPROM
Printer board error.
ROM check-sum.
Printer board error.
RAM
System error.
Main switch off / on.
Printer Error. Press "Copier/Printer/Scanner"
to resume job
Opt. ROM error
Press CONTINUE
Printer is out of order.
Call for service.
2-15
All manuals and user guides at all-guides.com
The printer's internal memory is running low.
Turn the main switch OFF and then ON again and then try to print one more time. You
can check the amount of user memory currently available by printing a status page.
The printer memory has become full during reception of data for a print job. Press the
"CONTINUE" key to resume printing (the page may break in some Pages). You can
abandon printing by the "CANCEL" key.
This message will also be displayed if you attempt to print more than the maximum
allowable 250 pages. In this case, print out a lesser number of copies.
Printing could not be accomplished correctly because the print job contains complex
data that could not synchronize with the printer engine. Press the displayed "CON-
TINUE" key to reprint the data.
There may be a problem with the Printer Board. Turn the main switch OFF and then ON
again, and then try to print one more time. If the error message remains even after
following the above procedure, contact your service representative, an authorized serv-
ice center or the place of purchase.
Procedure