Routine Maintenance; Control Panel - Lotus BCAO1618 Manual Del Usuario

8

Routine maintenance

Disconnect the power supply of the equipment
and wear adequate
equipment (e.g. gloves) before performing any
cleaning operation.
The user must only perform routine maintenance.
Contact the Service Centre to request the
assistance of an authorised technician for special
maintenance.
During the warranty period, the Manufacturer
does not acknowledge as collateral damage due
to a lack of maintenance or cleaning wrong (eg.
Use of unsuitable cleaning agents).
Do NOT use the following to clean any parts made of
steel or glass on the equipment and accessories:
- abrasive or powder detergents;
- aggressive or corrosive detergents (e.g. hydrochloric/muriatic
acid, sulphuric acid, caustic soda, etc.). Attention! Do not use
these substances to clean the substructure/floor under the
equipment;
- abrasive or sharp tools (e.g. abrasive sponges, scrapers, steel
brushes, etc.);
- steam or pressure water jets.
TUB, TOPS AND STAINLESS STEEL SURFACES
Clean all steel surfaces daily in order to maintain adequate levels
of hygiene.
Clean with a soft cloth soaked in warm soapy water or a specific
detergent for steel (follow the instructions of the detergent
manufacturer).
Finish by rinsing thoroughly and drying.
In the case of bain-marie, drain and dry the tub at the end of
every work day.

CONTROL PANEL

Clean the control panel (of any type) with a soft cloth dampened
with specific products for plastic surfaces (follow the instructions
of the detergent manufacturer).
Be sure that no detergent enters the control panel.
DISPLAYS (IF PRESENT)
Clean the glass of the displays with a soft cloth dampened with
specific glass products (follow the instructions of the detergent
manufacturer).
code T7100008 - 0215 - rev. 00
personal protective
17
28 - 08 - 2015
24° 24°
CLOSE
10° 10°
3 sec.
H O
2
11:30
24°
10°
P
EN
EN