Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Description of unit
3.5
Technical data
Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Special high-pressure hose:
Dimensions (L X W X H):
Vibration:
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6
Transportation
Pushing or pulling the unit
Pull out the handle (Fig. 2, Item 1) until it will come no further. Insert
the handle – push the buttons (2) on the spars, and then push in the
handle.
3.7
Transportation in vehicle
Secure the unit with a suitable fastening.
110 Volt AC, 50/60 Hz
13 A @ 110VAC
3 x 1.5 mm
– 6 m
2
1100 Watt
214 bar (21,4 MPa)
2.88 l/min
0.029 inch – 0.74 mm
43°C
30.000 mPa·s
40 kg
6,35 mm, 15 m-18 NPSM
605 x 540 x 745 mm
Spray gun does not
exceed 2.5m/s
2
80 dB (A) *
1
2
GB
4.
Starting operation
4.1
High-pressure hose, spray gun and separating
oil
1. Screw the pressure gauge (1) to the coating material outlet
(Fig. 3, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet on the pressure gauge (Fig. 3, Item 4).
3. Screw the spray gun (5) with the selected tip onto the high-
pressure hose.
4. Tighten the union nuts at the high-pressure hoses firmly so
that coating material does not leak.
1
4
5. Fill the oil cup with Piston Lube (Fig. 4). Do not use too much
Piston Lube, i.e. ensure that no Piston Lube drips into the
coating material container.
Piston Lube prevents increased wear and tear to the
packings.
Attention
8
Starting operation
2
3
Performance Series 850e
5
Publicidad
Capítulos
Tabla de contenido
