Fitting The Carrying Ring; Mounting The Cutting Attachment - Stihl FS 111 RX Manual De Instrucciones

English

Fitting the Carrying Ring

Polymer Version
1
For position of carrying ring see "Main
Parts".
Push the carrying ring (1) over the
N
drive tube.
Insert the M5 nut in the hex recess
N
in the carrying ring.
Fit the M5x14 screw.
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
16
Mounting the Cutting
Attachment
Laying down the machine
Switch off the engine
N
Lay down the machine so that the
N
mount for the cutting attachment
faces upward
Blocking the shaft
1
3
2
To mount and remove the cutting
attachments, the shaft (1) must be
blocked with the locking pin (2) or Allen
wrench (2). The parts are included in the
scope of delivery and are available as
special accessories.
Push the locking pin (2) or Allen
N
wrench (2) as far as it will go into the
hole (3) in the gear – press gently
Turn the shaft, nut or cutting
N
attachment until the locking pin
engages and the shaft is blocked
Mounting the STIHL PolyCut 20-3
Keep the supplement sheet for the
mowing head in a safe place.
2
WARNING
Only mount the mowing head with
doubled stepped support as shown
above.
Mounting the mowing head with a
threaded connection
Keep the supplement sheet for the
mowing head in a safe place.
FS 111 RX