Spark Plug - Stihl FS 111 RX Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the Spark Plug
1
2
3
Remove the cover (1).
N
Pull off the spark plug boot (2).
N
Unscrew the spark plug (3).
N
24
Checking the Spark Plug
Clean dirty spark plug.
N
Check electrode gap (A) and
N
readjust if necessary – see
"Specifications".
Rectify the problems which have
N
caused fouling of the spark plug.
Possible causes are:
Too much oil in fuel mix.
Dirty air filter.
Unfavorable running conditions.
WARNING
Arcing may occur if the adapter nut (1) is
loose or missing. Working in an easily
combustible or explosive atmosphere
may cause a fire or an explosion. This
can result result in serious injuries or
damage to property.
Use resistor type spark plugs with a
N
properly tightened adapter nut.
Installing the Spark Plug
Screw the spark plug (3) into the
N
cylinder.
Tighten down the spark plug (3) with
N
the combination wrench.
A
Press the boot (2) firmly onto the
N
spark plug.
Fit the cover (1) and screw it down
N
firmly.
1
FS 111 RX

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido