Radio Reception; Usb Device Playback - Sony MEX-GS820BT Manual De Instrucciones

Radio reception

Stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
– If your car has built-in radio antenna
(aerial) in the rear/side glass, connect an
REM OUT lead (blue/white striped) or
accessory power supply lead (red) to the
power supply lead of a car's antenna
(aerial) booster.
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not
extend, check the connection of the
power antenna (aerial) control lead.
 The tuning step setting has been erased.
– Set the tuning step again (page 7).
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program
type.
CD playback
The disc does not play.
 Defective or dirty disc.
 The CD-R/CD-RW is not for audio use
(page 24).
MP3/WMA/AAC files cannot be played.
 The disc is incompatible with the MP3/
WMA/AAC format and version. For details
on playable discs and formats, visit the
support site (page 41).
MP3/WMA/AAC files take longer to play
than others.
 The following discs take a longer time to
start playback.
– A disc recorded with a complicated tree
structure.
– A disc recorded in Multi Session.
– A disc to which data can be added.
The sound skips.
 Defective or dirty disc.

USB device playback

You cannot play items via a USB hub.
 This unit cannot recognize USB devices via
a USB hub.
A USB device takes longer to play.
 The USB device contains files with a
complicated tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-
bit-rate.
 DRM (Digital Rights Management) files
may not be playable in some cases.
The audio file cannot be played.
 USB devices formatted with file systems
other than FAT16 or FAT32 are
unsupported.*
* This unit supports FAT16 and FAT32, but some USB
device may not support all of these FAT. For
details, refer to the operating instruction of each
USB device or contact the manufacturer.
Operations for skipping an album,
skipping items (Jump mode), and
searching a track by name (Quick-
BrowZer) cannot be performed.
 These operations cannot be performed
when a USB device in Android mode or
iPod is connected.
– Set [USB MODE] to [MSC/MTP] (page 19).
– Remove the iPod.
 The USB mode of the device is not set to
the appropriate mode.
– Make sure that the USB mode of the
device is set to MSC/MTP mode.
The sound cannot be output during
playback in Android mode.
 While the unit is in Android mode, the
sound outputs only from the Android
smartphone.
– Check the status of the audio playback
application on the Android smartphone.
– Playback may not perform properly
depending on the Android smartphone.
29
GB