Getting Started; Detaching The Front Panel; Resetting The Unit; Switching The Fm/Am Tuning Step - Sony MEX-GS820BT Manual De Instrucciones

Getting Started

Detaching the Front Panel

You can detach the front panel of this unit to
prevent theft.
1 Press and hold OFF  until the unit
turns off, press the front panel
release button , then pull the panel
towards you to remove.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Serial numbers
Make sure the serial numbers on the bottom
of the unit and the back of the front panel
are matched correctly. Otherwise you cannot
make BLUETOOTH pairing, connection and
disconnection by NFC.
Attaching the front panel

Resetting the Unit

Before operating the unit for the first time,
or after replacing the car battery or
changing connections, you must reset the
unit.
Press RESET on the inner panel with a ball-
point pen, etc., after detaching the front
panel.
Note
Resetting the unit will erase the clock setting and
some stored contents.
Setting the display language
After resetting the unit, the display
language setting display appears.
1
Press ENTER while [SET LANGUAGE] is
displayed.
The display language currently set
appears.
2
Rotate the control dial to select
[ENGLISH] or [SPANISH], then press it.
The setting is complete and the clock is
displayed.
This setting can be configured in the general
setup menu (page 19).
Switching the FM/AM
Tuning Step
Set the FM/AM tuning step of your country.
This setting appears only while the source
is off and the clock is displayed.
1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [SET
TUNER-STP], then press it.
3
Rotate the control dial to select from
[SET 50K/9K], [SET 100K/10K] or [SET
200K/10K], then press it.
7
GB