Messages - Sony MEX-GS820BT Manual De Instrucciones

Messages

The following messages may appear or flash
during operation.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during
iPod playback.
OUTPUT ERROR: There may be an internal
malfunction.
 Check the connection. If the error
message still remains on in the display,
consult your nearest Sony dealer.
READ: Now reading information.
 Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
TEMP CAUTION: The thermal protector is
activated.
 Reduce the volume.
(underscore): The character cannot be
displayed.
For CD playback:
CD ERROR: The disc cannot be played. The
disc will be ejected automatically.
 Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO DISC: There is no disc.
 Insert a disc containing playable files
(page 25).
CD NO MUSIC: There is no playable file. The
disc will be ejected automatically.
 Insert a disc containing playable files
(page 25).
CD PUSH EJT: The disc could not be ejected
properly.
 Press  (eject).
32
GB
or : The beginning or the end
of the disc has been reached.
For USB device playback:
HUB NO SUPRT: USB hubs are not
supported.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start
playback.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 19).
USB ERROR: The USB device cannot be
played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected
or recognized.
 Make sure the USB device or USB cable is
securely connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable
files (page 26).
USB NO SUPRT: The USB device is not
supported.
 For details on the compatibility of your
USB device, visit the support site
(page 41).
USB OVERLOAD: The USB device is
overloaded.
 Disconnect the USB device, then press SRC
to select another source.
 The USB device has a fault, or an
unsupported device is connected.