8.3 USING AN EXTENSION CORD
The use of an extension cord is not recommended. If you must use an extension
cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as
those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger, as specified:
Length of cord (feet)
AWG* size of cord
*AWG-American Wire Gauge
9. ASSEMBLY INSTRUCTIONS
9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.
10. FEATURES
11. CONTROL PANEL
LED INDICATORS
CLAMPS REVERSED/BAD BATTERY (red) LED flashing:
The connections are reversed.
CLAMPS REVERSED/BAD BATTERY (red) LED lit: The charger has detected
a problem with the battery. See Troubleshooting for more information.
CHARGING (yellow/orange) LED lit: The charger is charging the battery.
CHARGED (green) LED lit: The battery is fully charged and the charger
is in maintain mode.
NOTE: See Operating Instructions for a complete description of the charger modes.
25
50
100
18
18
18
1
1. Battery status LEDs
2. Battery clamps (quick-connect)
3. Ring connectors (quick-connect)
2
3
• 6 •
150
16