Schumacher SC1319 Manual Del Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE 50 AMP BATTERY CLAMPS
1. Connect the end of the charger output cable to the end of the battery cable,
quick-connect and clamps.
2. Follow the steps in sections 6 and 7, to connect the output clamps to the battery.
3. Connect the charger to an electrical power outlet.
USING THE RING CONNECTORS
1. To permanently attach to a battery, loosen and remove each nut from the bolt
at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Connect the charger to an electrical power outlet.
BATTERY CHARGING TIMES
BATTERY SIZE/RATING
SMALL BATTERIES
Motorcycle, garden tractor, ATV, etc.
Times are based on a 50% discharged battery and may change, depending on age
and condition of battery.
AUTOMATIC CHARGING MODE
When an Automatic Charge is performed, the charger switches to the maintain
mode automatically after the battery is charged.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging aborts,
the charger's output is shut off and the CLAMPS REVERSED/BAD BATTERY
(red) LED will light. Do not continue attempting to charge this battery. Check the
battery and replace, if necessary.
DESULFATION MODE
Desulfation could take 8 to 10 hours. If desulfation fails, the CLAMPS REVERSED/
BAD BATTERY
COMPLETION OF CHARGE
Charge completion is indicated by the CHARGED
charger has switched to the maintain mode of operation.
(red) LED will light.
6-12 Ah
12-32 Ah
• 8 •
CHARGE TIME (1.5A)
2½-5 h
5-13¼ h
(green) LED. When lit, the

Publicidad

Tabla de contenido
loading

Tabla de contenido