Metabo HPT C 10FSH C 10FSHS Instrucciones De Seguridad Y Manual De Instrucciones página 13

(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in Fig. 9-b and Fig. 9-c following the same procedure for right
angle cutting.
CAUTION:
After adjusting the table insert for right angle cutting, the table insert will be cut to
some extent if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust the table insert for bevel angle
cutting.
3. Checking the saw blade lower limit position
Check that the saw blade can be lowered 13/32" to 7/16" (10mm to 11mm) below the table insert as shown in
Fig. 10.
When you replace a saw blade with a new one, adjust the lower limit position so that the saw blade will not cut
the turntable or complete cutting cannot be done.
To adjust the lower limit position of the saw blade, follow the procedures (1) to (4) indicated below. (Fig. 11)
Furthermore, when changing the position of a 8mm depth adjustment bolt that serves as a lower limit position
stopper of the saw blade, it becomes necessary to shift the position of a 8mm hexagon socket set screw that
is in the screw hole for the 8mm depth adjustment bolt that serves as the stopper.
Gear Case
8mm Wing Nut
Saw Blade
Turntable
Base
Fig. 10
8mm Hexagon Socket
8mm Depth
Set Screw
Adjustment Bolt
Loosen
Gear Case
8mm Wing Nut
Fig. 11
4. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 3-11/32" (85mm) in height in right-angle cutting or
2-3/16"(55mm) in left bevel angle cutting or 1-3/16" (30mm) in right bevel angle cutting,
adjust the lower limit position so that the base of the motor head (see Fig. 10) will not come
in contact with the workpiece.
To adjust the lower limit position of the saw blade, follow the procedures (1) to (3) shown in Fig. 11-a.
(1) Loosen the 8mm wing nut so that the 8mm depth adjustment bolt can be turned by hand.
(2) Lower the motor head, and thru the 8mm depth adjustment bolt by hand and make adjustments so that
there can be a clearance of 3/32" to 1/8" (2mm to 3mm) between the lower limit position of the motor head
and the top of the workpiece at the saw blade's lower limit position (where the head of the 8mm depth
adjustment bolt contacts the gear case.
(3) After adjustment, turn the 8mm wing nut until it contacts the Hinge (see Fig. 11), and fully tighten it.
(1) Loosen the 8mm wing nut.
(2) Insert your 6mm hexagon bar wrench from behind of the tool and turn
the 8mm hexagon socket set screw to the left (counterclockwise) as
viewed from behind of the tool.
(3) Turn the 8mm depth adjustment bolt, change the height where the
bolt head and the gear case contacts, and adjust the lower limit
position of the saw blade. One turn of the 8mm depth adjustment
bolt changes the lower limit position of the saw blade by about
8mm Depth
5/16"(8mm), and this information can be used as a rough guide.
Adjustment
Bolt
(4) Turn the 8mm hexagon socket set screw to the right (clockwise) as
viewed from behind of the tool, and let it softly contact the tip of the
8mm depth adjustment bolt.
Turn
Hinge
English
13