Practical Applications - Metabo HPT C 10FSH C 10FSHS Instrucciones De Seguridad Y Manual De Instrucciones

PRACTICAL APPLICATIONS

WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the
tool is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 22).
Line
1. Switch operation
Lock-off button
Switch trigger
Fig. 23
WARNING:
Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly start operating,
which could result in injury.
2. Using the Vise Assembly (Standard accessory)
Screw Holder
6mm
Knob Bolt
V-Groove
Groove
Fence
6mm Knob Bolt
Fig. 24
WARNING:
Always fi rmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
Warning Sign
Fig. 22
The tool will not start unless the Lock-off button is pressed while the switch is
pulled back.
The Lock-off button can be engaged by pressing it from the left.
After the switch is on, the saw blade will continue to operate as long as you pull on
the switch trigger, even if you release the Lock-off button.
When the switch is released, the Lock-off button automatically disengages to
prevent inadvertent motor startup.
The vise assembly can be mounted on either the left fence (Fence (B))
or the right fence (Fence (A)), and can be raised or lowered according
Knob
to the height of the workpiece.
To raise or lower the vise assembly, fi rst loosen the 6mm knob bolt. As
shown in Fig. 24, the vise shaft has three locking grooves into which
Vise
the tip of the 6mm wing bolt is designed to fi t in order to lock the screw
Plate
holder in the desired position.
To ensure that the tip of the 6mm wing bolt is properly aligned with the
desired locking groove on the vise shaft, simply align the upper surface
Work piece
of the fence to either of three v-grooves on the vise shaft surface or to
the lower surface of the screw holder.
Therefore, the vise assembly can be attached in either of three
positions to ensure proper height adjustment.
After adjusting the height, fi rmly tighten the 6mm wing bolt; then turn
the upper knob, as necessary, to securely attach the workpiece in
position.
Warning Sign
Line
English
17