Metabo HPT C 10FSH C 10FSHS Instrucciones De Seguridad Y Manual De Instrucciones página 22

English
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 34 (see Fig. 37; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the lower surface (
Miter Angle Scale
(3) Setting to cut crown moldings at positions 1 and 4 in Fig. 34 (see Fig. 40; tilt the head to the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the upper surface (
(4) Setting to cut crown moldings at positions 2 and 3 in Fig. 34 (see Fig. 41; tilt the head to the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings: 35.3° ( mark)
* For 38° type crown moldings: 31.6° ( mark)
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings: 30° ( mark)
* For 38° type crown moldings: 33.9° ( mark)
3 Position the crown molding so that the lower surface (
Head
4
Miter Angle Scale
22
Head
Bevel Angle Scale
1
4
Fence
Base
Turntable
Fig. 36
Fence
Table on Base
Fig. 38
Bevel Angle Scale
1
Fence
Base
Turntable
Fig. 40
in Fig. 33) contacts the fence as in Fig. 39.
Head
Bevel Angle Scale
3
2
Fence
Miter Angle Scale Turntable
Fig. 37
Fence
Table on Base
Fig. 39
in Fig. 33) contacts the fence as indicated Fig. 42.
in Fig. 33) contacts the fence as in Fig. 43.
Head
3
Fence
Miter Angle Scale
Turntable
Fig. 41
Base
Bevel Angle Scale
2
Base