The Set Setting Menu; Power Saving - Sony VPL-VW12HT Manual De Instrucciones

The SET SETTING Menu

The SET SETTING Menu
The SET SETTING menu is used for changing the
settings of the projector.
SET SETTING
STATUS: ON
INPUT-A: COMPONENT
INPUT-B: COMPONENT
LANGUAGE: ENGLISH
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
CINE MOTION: AUTO
STATUS (on-screen display)
Sets up the on-screen display.
ON: Shows all of the on-screen display.
OFF: Turns off the on-screen display except for the
menus, a message when turning off the power,
and warning messages.
INPUT-A
Selects the computer, component, DTV YP
DTV GBR signal input from the INPUT A
connectors.
Note
If the setting is not correct, "Please check INPUT-A
setting." appears on the screen and the color of the
picture becomes strange or the picture is not
displayed.
INPUT-B
Selects the computer, component, DTV YP
DTV GBR signal input from the INPUT B
connectors.
Notes
• If the setting is not correct, "Please check INPUT-B
setting." appears on the screen and the color of the
picture becomes strange or the picture is not
displayed.
• Set the progressive component signal, e.g. DVD, to
"COMPONENT"; 15k RGB signal, e.g. game
machines, to "DTV GBR."
30
(GB)
INPUT-A
P or
B R
P or
B R
The signals that can be output for each setting of
INPUT-A and -B are as shown below.
Setting of INPUT -A and -B
Signal
COMPUTER COMPONENT DTV YP
15k RGB –
(DVD output in
PAL system, etc.)
Component –
Progressive –
Component
(Progressive
DVD output, etc.)
DTV (Digital BS –
output, etc.)
Computer
: can be output – : cannot be output
LANGUAGE
Selects the language used in the menu and on-screen
displays.
Available languages are: English, French, German,
Italian, Spanish, Japanese and Chinese.

POWER SAVING

When set to ON, the projector goes into the power
saving mode if no signal is input for 10 minutes.
The power saving mode is canceled when a signal is
input or any key is pressed.
SIRCS RECEIVER
Selects the remote control detectors (SIRCS receiver)
on the front and rear of the projector.
FRONT & REAR: Activates both the front and rear
detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
CINE MOTION
Selects either position according to the signal source
for the NTSC , 15k RGB (60 Hz) or 525/60
3.58/4.43
signal.
AUTO: Set to AUTO when the input signal is from
a film-originated material. 2-3 pull down is
applied.
OFF: 2-3 pull down is not applied.
Note
This function will not operate for signals of 50 Hz.
P DTV GBR
B R
– –
–
–
–
– – –