The Install Setting Menu - Sony VPL-VW12HT Manual De Instrucciones

The INSTALL SETTING
Menu
The INSTALL SETTING menu is used for changing
the install settings of the projector.
INSTALL SETTING
KEYSTONE MEM: OFF
DIGIT KEYSTONE: 0
INSTALLATION: FLOOR-FRONT
CINEMA BLACK: ON
LAMP TIMER: 234h
KEYSTONE MEM
ON: The DIGIT KEYSTONE setting is stored.
The data is retrieved when the projector power is
turned on. The setting will remain the same every
time.
OFF: The DIGIT KEYSTONE is reset to 0 when the
power is turned on next time.
DIGIT KEYSTONE
Corrects the trapezoidal distortion caused by the
projection angle.
If the base edge of the image is longer, set a negative
value; if the upper edge is longer, set a positive value
to display the image as a rectangle.
Note
Only if "ZOOM," "FULL," or "NORMAL" has been
selected in ASPECT of the INPUT SETTING menu,
you can change the trapezoidal dimensions.
INPUT-A
INSTALLATION
Set this item to reverse the picture horizontally or
vertically.
FLOOR-FRONT: The picture is not reversed.
CEILING-FRONT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed
horizontally.
CEILING-REAR: The picture is reversed
vertically.
Note
When using a mirror, be careful of how the
installation is carried out since the picture may be
reversed.
CINEMA BLACK
Switches the lamp wattage during projection.
OFF: Normal wattage.
ON: Enhances the black by reducing the lamp
wattage.
Notes
• It will take a few seconds for the projector to change
the lamp wattage during projection.
• If the CINEMA BLACK is set to ON, it starts with
OFF when the power is turned on, then changes to
ON after a while.
LAMP TIMER
Indicates how long the lamp has been turned on.
Note
This only displays the time. You cannot alter the
display.

The INSTALL SETTING Menu

31
(GB)