Publicidad
⑦
⑨
10
13
12
24
English
⑧
To replace fabric covering, ensure it is turned right side out, and stretch the
covering over pad ⑦, and adjust the covering to lie smoothly ⑧. Then push
the rectangular collar through the pad assembly and adjust into final position,
making sure it is not twisted ⑨. If tab that says EMERGENCY TAB is drawn
out, draw back the strap of the tab until it stops at the guide 10 .Fold flat and
cover the strap of the tab with the fabric covering as shown 11 .
11
WARNING:
outside the guide on the cheekpad, as the strap loop may be caught by
projecting objects when riding.
To replace cheekpad in helmet, slip pad onto strap.
Place the rear tab toward the rear of the helmet 12 and push the forward
part of pad until the front tab is locked in place 13 .
14
Replace the neckroll tab into place 14 .
ABOUT EMERGENCY RELEASE SYSTEM: The EMERGENCY RELEASE SYSTEM
is to smoothly remove cheekpads that may be a hindrance when rescuers
attempt to remove helmet from an injured helmet wearer. With the label that
says EMERGENCY TAB located between the shell and the cheekpad at each side,
rescuers can recognize that the helmet is equipped with the EMERGENCY RELEASE
SYSTEM and the cheekpads can be removed by pulling the tab downward.
WARNING:
and should not be used for routine, everyday removal of the cheekpads,
otherwise cheekpad damage may occur.
Do not allow more than the tab of the strap to be exposed
The EMERGENCY RELEASE SYSTEM is for "emergencies only"
Publicidad
Capítulos
