Publicidad
①
6
②
English
WARNING:
If your shield becomes too scratched or uncleanable, replace it with a new one.
Impaired visibility causes accidents.
Use a solution of mild soap or detergent and lukewarm water to clean your
shield. Rinse well with clean water, and wipe off with a soft cloth. Never use
petrol, thinner, benzene or any other solvents. There are many "aggressive"
cleaners on the market, including some supposed to be specifically for use on
shield. Arai strongly recommends that you do not use any such products to
clean your shield as some of their ingredients may have damaging effects on
the shield and other plastic parts installed on your helmet.
Do not apply stickers or adhesive tape to the shield, as this will weaken the hard
coating. If tinted, the shield is for daylight use only.
TO OPERATE DEMIST SYSTEM
A demist function is incorporated in the shield latch system to allow more
rapid clearing of any interior mist with the shield remaining partially latched.
Push the shield latch lever up to release shield into the demist position to
assist moisture dispersal ①. To close the shield completely, push the shield
down until the latch post fully engages the shield and latch lever captures the
bottom of the shield ②.
TO OPERATE BROWVENTS
The Browvents are operated from fully closed, through intermediate, to fully
open position by simply sliding the vent control up to open, sliding down to close.
Publicidad
Capítulos
