PRESIDENT HENRY ASC Classic 12/24 V Manual Del Usuario página 27

2) ANTENNA INSTALLATION
a) Choosing your antenna
- For CB radios, the longer the antenna, the better its results. Your dealer will be able
to help you with your choice of antenna.
b) Mobile antenna
- Must be fixed to the vehicle where there is a maximum of metallic surface (ground
plane), away from windscreen mountings.
- If you already have a radio-telephone antenna installed, the CB antenna should be
higher than this.
- There are two types of antenna: pre-regulated which should be used on a good
ground plane (e.g. car roof or lid of the boot), and adjustable which offer a much
larger range and can be used on a smaller ground plane (see § 5, Adjustment of
SWR).
- For an antenna which must be fixed by drilling, you will need a good contact be-
tween the antenna and the ground plane. To obtain this, you should lightly scratch
the surface where the screw and tightening star are to be placed.
- Be careful not to pinch or flatten the coaxial cable (as this runs the risk of break down
and/or short-circuiting).
- Connect the antenna (B).
c) Fixed antenna
- A fixed antenna should be installed in a
clear a space as possible. If it is fixed to a
mast, it will perhaps be necessary to stay it,
according to the laws in force (you should
seek professional advice). All PRESIDENT
antennas and accessories are designed
to give maximum efficiency to each CB
radio within the range.
3) POWER CONNECTION
a) Check that the battery is of 12 or 24 volts.
b) Locate the positive and negative terminals of the battery (+ is red and - is black).
c) It is necessary to connect your CB to a permanent (+) and (-). We advise you to
d) Connect the red wire (+) to the
e) Connect the power cable to your
OUTPUT RADIUS PATTERN
27
Your PRESIDENT HENRY ASC Classic12/24 V is protected against an inversion of polarities.
However, before switching it on, you are advised to check all the connections. Your
equipment must be supplied with a continued current of 12 or 24 volts (A). Today,
most cars and lorries are negative earth. You can check this by making sure that the
negative terminal of the battery is connected either to the engine block or to the
chassis. If this is not the case, you should consult your dealer.
Should it be necessary to lengthen the power cable, you should use the same or a
superior type of cable.
connect the power cable directly to the battery (as the connection of the CB cable
to the wiring of the car-radio or
other parts of the electrical circuit
may, in some cases, increase the
likelihood of interference).
positive terminal of the battery
and the black (-) wire to the
negative terminal of the battery.
CB radio.
WARNING: Never replace the original fuse (2 A) by one of a different value.