Maruyama MCV31R Manual Del Propietario U Operador página 27

3. Push the primer pump until fuel enters into the primer
pump (5 - 6 times).
4. Pull the choke knob to the extended position.
This makes the choke valve closed and sets the throttle
trigger to the start position .
5. Place the chainsaw on the ground and hold the front
handle firmly with your left hand. Kneel with your right
knee on the frame and pull the starter grip with your
right hand.
6. If the engine stalls after the first firing, push the chock
knob back in and pull the starter grip again.
7. After the engine is started, immediately squeeze and
release the throttle trigger to allow it to return to the idle
position.
8. After the engine starts, pull the hand guard toward the
handle to disengage the chain brake.
Do not increase engine speed with the chain brake
engaged.
This may cause excessive heat to covers or damage to
the clutch.
9. If the engine stalls at low speed, refer to "CARBURETTOR
ADJUSTMENT" in Regular maintenance.
Primer pump
Front hand guard
— US-26 —
Choke knob
Release the
chain break