Maruyama MCV31R Manual Del Propietario U Operador página 30

CHAIN BRAKE
• Check operation of chain brake before starting chainsaw. If the chain brake does not function
properly, take the saw to your local Service Center.
• If the brake is tripped by kick back reaction, the chain will stop. Immediately release the throttle
to avoid possible damage to the engine or clutch. Do not attempt to operate the engine with the
brake engaged.
• Chain brake is the device to stop the rotation of the chain if activated in a kickback situation.
• When the front guard is pushed forward, chain
brake instantly works to stop the chain.
• When the front guard is fully pulled toward the han-
dle, brake is released.
CHECKING THE BRAKE FUNCTION OF THE BRAKE
1. Place the chain saw on the ground.
2. Hold the handle with both hands and accelerate the engine to high speed by using the throttle trigger.
3. Operate the chain brake by turning your left wrist against the front hand guard whilst gripping the front handle.
4. The chain stop immediately.
5. Release the throttle trigger.
6. If the chain brake does not function properly, take the saw to your local Service Center.
CAUTION
k
— US-29 —
Front hand guard
Chain stop
Front hand guard
Release the
chain brake