STORAGE
POTENTIAL HAZARD
• Gasoline contains gasses that can build up pressure inside a fuel tank.
WHAT CAN HAPPEN
• fuel can be sprayed on you when removing fuel tank cap.
HOW TO AVOID THE HAZARD
• Remove fuel tank cap slowly to avoid injury from fuel spray.
POTENTIAL HAZARD
• Saw chain is sharp.
WHAT CAN HAPPEN
• Contact with the saw Chain can cause personal injury.
HOW TO AVOID THE HAZARD
• Wear gloves when you handle the saw chain.
POTENTIAL HAZARD
• Oil may squirt out of the spark plug opening when you pull the starter grip.
WHAT CAN HAPPEN
• Oil can cause eye injuries.
HOW TO AVOID THE HAZARD
• Protect your eyes and keep your face away from the spark plug opening.
For long term storage of the chain saw :
1. Empty the fuel tank into a suitable fuel storage container approved for gasoline.
2. Pump the primer bulb on the carburetor until all fuel is discharged through the clear Primer pump.
3. Run the engine to remove any fuel that may remain in the carburetor.
4. Perform all regular maintenance procedures and any needed repairs.
5. Remove the spark plug and squirt a very small amount of oil into the cylinder.
6. Pull the starter grip once.
7. Slowly pull the starter grip to bring the piston to the top of the cylinder (TDC).
8. Reinstall the spark plug.
9. Store the Chain saw in a dry place away from excessive heat, sparks or open flame.
10. Always use a guide bar cover when carrying or storage a chain saw.
WARNING
k
WARNING
k
CAUTION
k
— US-43 —