Fitting The Carrying Ring - Stihl FS 565 Manual De Instrucciones

Adjusting and securing the loop
handle
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommended distance (A): about
14 in (35 cm)
N Loosen the screw on the handle.
N Slide the handle to the required
position.
N Tighten down the screw so that the
handle cannot be rotated on the
drive tube.
FS 56, FS 56 R, FS 56 C, FS 56 RC

Fitting the Carrying Ring

Version with bike handle
The carrying ring comes standard with
the machine or is available as a special
accessory.
1
1
2
N Position of carrying ring: see "Main
Parts".
N Place the clamp (1) against the
drive tube with the tapped hole on
the left (viewed from engine).
N Squeeze the two ends of the clamp
together and hold in that position.
N Insert the M6x14 screw (2).
N Line up the carrying ring.
N Tighten down the screw firmly.
Version with loop handle
The carrying ring is integrated in the
front end of the control handle.
English
19