Fitting And Adjusting The Carrying System; Adjusting The Bike Handle; Balancing The Trimmer; Inserting And Removing Connecting Cable Plug - Stihl FSA 130 Manual De Instrucciones

English
3
The length of the connecting cable can be adjus‐
ted by making a loop (1) and securing it to the
belt bag (3) with the fastener (2).
► Arrange the connecting cable so that it is as
short as possible without hindering your work.
7.3.3 Fitting and Adjusting the Carrying Sys‐
tem
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the cara‐
biner (2) is about a hand's width below your
right hip.
7.4

Adjusting the Bike Handle

The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter and pull the con‐
necting cable plug out of the socket.
► Hook the brushcutter from the carrying strip
into the carabiner of the carrying system.
► Loosen the wing screw (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten down the wing screw (1) firmly.
36
2
1
1
2
2
1

8 Inserting and Removing Connecting Cable Plug

7.5

Balancing the Trimmer

► Switch off the trimmer and pull the connecting
cable plug out of the socket.
1
2
► Hook the carrying strip (2) onto the carabi‐
ner (1).
► Let go of the trimmer and check to see how it
is balanced - the cutting attachment should
just rest on the ground.
► If the trimmer cannot be balanced: Change the
attachment point of the carabiner (1) on the
carrying strip (2) and check balance again.
8 Inserting and Removing
Connecting Cable Plug
8.1 Inserting the Connecting Cable
Plug
► Hold connecting cable plug (1) so that the
arrow on its side lines up with the arrow on the
socket (2).
► Insert the connecting cable plug (1) in the
socket (2).
The plug (1) engages in position.
1
2
0458-726-9821-D