Miter Detent System - Bosch CM8S Instrucciones De Funcionamiento

Ocultar thumbs Ver también para CM8S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 17
WARNING
source
before
adjustments or repairs.
Calibrating Miter Detent System
1. Engage the miter detent at the 0° position. Loosen
the miter lock knob 1/2 turn.
2. Look for four round holes in the miter scale plate.
In each hole is a screw. Use a Philips screwdriver
to loosen all four screws 1 to 2 turns. This will
loosen the miter detent plate (see figure 12).
3. Slide the head assembly completely to the back
and engage the slide rail lock knob by tightening
the knob to the right (clockwise) (item 25 - page 9).
4. Lock saw down using the head assembly lock pin
(item 36 – page 9).
5. Hold one side of a 90° combination square against
the fence and rotate the table (and detent plate)
until the side of the saw blade plate is in full
contact with the other side of the square...do not
contact the blade teeth with the sqaure (figure 13).
6. Tighten all four screws – loosen and reset the
miter scale pointer to the "0" position.
Miter Scale pointer Adjustment
1. Rotate table to 0° detent position and lock in
place.
2. Raise the head assembly to the full UP position.
3. Loosen the pointer adjust screw that holds the
miter scale pointer in place (see figure 14).
4. Position the pointer to align with the 0° line.
Tighten the screw.
Adjustments

Miter Detent System

To
avoid
possible
disconnect plug from power
performing
any
assembly,
injury,
FIG. 12
Screws
Contacting
Fence
Combination
Square
pointer
FIG. 14
Adjust
Screws
Miter Scale
pointer
17.
Detent plate
Contacting
FIG. 13
Blade
Set Miter
Detent at 0°

Publicidad

Tabla de contenido
loading

Tabla de contenido