Mounting (Rack) - Tripp-Lite SmartOnline Manual Del Propietário

2. Installation

2.1 Mounting (Rack)

• Use the included rackmount shelves and mounting hardware to mount the UPS system in a 4-post
rack or rack enclosure. To mount the UPS system in a 2-post (telecom) rack, order Tripp Lite's 2-Post
Rackmount Kit (model 2POSTRMKITWM, sold separately).
• The instructions in this manual are for common rack and rack enclosure types and may not be
appropriate for all mounting applications. The user must determine the fitness of hardware and
procedures before mounting. If hardware or procedures are not suitable for the application, contact the
manufacturer of the rack or rack enclosure for a solution. Warning: The UPS system is very
heavy—be careful when moving or lifting it.
4-Post Mounting Procedure
1
The included plastic pegs
rackmount shelves
hardware is installed. Insert a peg near the center of
the front and rear bracket of each shelf as shown.
(Each front bracket has 6 holes and each rear
bracket has 3 holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to
match the depth of the vertical rack rails. The pegs
will fit through the square holes in the rack rails to
support the shelves. Confirm that the shelves are
level in all directions. Note: The support ledge of
each shelf must face inward.
2
Secure the shelves
using the longer included screws and washers
shown. (Place 4 screws at the front and 4 screws at
the back.) Tighten all screws before proceeding.
Warning: Do not attempt to install the UPS system
until the required screws have been inserted and
tightened. The plastic pegs will not support the
weight of the UPS system.
3
Attach the mounting brackets
mounting holes of the UPS system using the
shorter included screws
ears must face forward.
4
With the aid of an assistant, lift the UPS system
and slide it onto the mounting shelves. Insert 4 of
the included screws
bracket ears and into the vertical rack rails. Tighten
all screws securely.
201102140 932835.indb 3
will support the empty
A
until the permanent mounting
B
B to the rack rails permanently
to the forward
D
E . The mounting bracket
through the mounting
F
B
A
1
B
C
2
C as
D
E
3
F
4
3
A
B
C
B
E
D
F
3/29/2011 4:50:11 PM