Astralpool VICTORIA PLUS SILENT VS Manual De Instrucciones página 6

WARNINGS DURING INSTALLATION AND ASSEMBLY WORK
- In cases of junction box connections only: when connecting the electrical wiring to the motor, check the
layout inside the connection box and make sure there are no pieces of wiring inside after it has been closed
and that the earthing conductor is correctly connected. Connect the motor in line with the wiring diagram
attached to the machine.
- In cases of junction box connections only: make sure that the electrical wiring connections to the terminal
box are well mounted and screwed tightly to the connection terminals.
- The unit should be connected to an alternating current supply (see data on the pump's plate) with an earth
connection, protected by a residual current device (RCD) with a rated residual operating current that does
not exceed 30 mA.
- Ensure the seal of the motor's junction box is properly fitted to prevent water getting in. Likewise, position
and tighten the gland inside the cable duct of the junction box.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Where the intended use is not as indicated, additional technical adaptations and regulations may apply.
WARNINGS DURING START-UP
- Before starting the machine, check the calibration of the electric protection devices on the motor and that the
protection against electrical and mechanical contacts is correctly positioned and secure.
NOTE
The pool should not be used while the pump unit is running.
Do not use the pump if anyone is in contact with water.
WARNINGS DURING ASSEMBLY AND MAINTENANCE WORK
- Follow local installation regulations when assembling and installing the pumps.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Avoid contact at all times - even accidentally - with moving parts while the unit is running and/or before it
comes to a complete standstill.
- Wait for the unit to come to a halt before handling it.
- Before any electrical or mechanical maintenance operation, disconnect the unit from the power supply and
block the start-up devices.
6
Installation and general maintenance manual - POOL PUMPS