Before Startup; Start Up - Kärcher HD 3.5/30-4S Ea Manual Del Usuario

Before Startup

Unpacking
– Check the contents of the pack be-
fore unpacking.
– In case of transport damage inform
vendor immediately.
Check oil level
 Read the oil level display when the
device is not running. The oil level
must be above the two pointers.
Activate deaeration of oil
container
 Unscrew the fastening screws of
the device hood; remove the device
hood.
 Cut off tip of oil container cover
 Fasten the device hood.
Install hand spray gun, spray
lance and nozzle
Note: The EASY!Lock system joins
components with a quick-fasten thread
solidly and securely with just one turn.
1.
 Insert the high pressure nozzle onto
the spray lance.
 Install union nut and hand-tighten it
(EASY!Lock).
 Join the spray lance with the trigger
gun and tighten until hand-tight
(EASY!Lock).
2.
Attaching the Accessories
 Join the high-pressure hose with
trigger gun and high-pressure con-
nection of the appliance and tighten
until hand-tight (EASY!Lock).
 Lock a cable clip in the side-hole on
the handle.
WARNING
Risk of injury! Appliance, accessories,
supply lines and connections must be
in fault-free condition. If they are not in
a perfect state then the appliance must
not be used.
Electrical connection
DANGER
Danger of injury by electric shock.
– It is imperative to connect the appli-
ance to the electric mains by means
of a plug. It is forbidden to perma-
nently connect the appliance to the
power supply. The plug serves for
the disconnection from the mains.
– The appliance may only be con-
nected to alternating current.
– Minimum fuse strength of the sock-
et (see Technical Data).
– The highest allowed net impedance
at the electrical connection point
(refer to technical data) is not to be
exceeded. In case of confusion re-
garding the power impedance pre-
sent on your connection, please
contact your utilities provider.
– Use the extension cord that has an
adequate cross-section (see "Tech-
nical Data") and unwind it fully from
the cable drum.
For connection values, see type plate/
technical data.
 Unwind the mains cable and place it
on the floor.
– 5
EN

Start up

7