Ryobi RTS11 Manual Del Operador página 15

ASSEMBLING THE STAND
See Figures 6 - 8.
NOTE: Do not use this leg stand with other equipment or
for other purposes.
 Lay outside support bracket, on a flat surface. Place inside
support bracket on top of outside support bracket with
the top rails facing each other.
 Insert stand legs into the support brackets. Angled ends
of stand legs should face away from each other so they
resemble a "V".
 Place hinge R between leg assembly on right side. Repeat
with hinge F on left side.
 Carefully align holes in legs and hinge. Install hardware
through holes.Tighten hardware securely.
INSIDE
SUPPORT
BRACKET
OUTSIDE
SUPPORT
BRACKET
INSIDE
SUPPORT
STAND
BRACKET
HINGE (F)
OUTSIDE
SUPPORT
BRACKET
ASSEMBLY
STAND LEG
HOLES
Fig. 6
STAND
HINGE (R)
Fig. 7
MOUNTING THE TABLE SAW TO THE LEG
STAND
See Figure 9.
WARNING:
Do not lift the saw without help. The saw weighs
approximately 55 lbs. Hold it close to your body. Keep
your knees bent and lift with your legs, not your back.
Ignoring these precautions can result in back injury.
 Place the stand on level ground and open to its fully
extended position.
 Position the table saw onto the stand so that the holes in
the saw's frame are aligned with the holes in the stand's
brackets.
NOTE: Make sure the table saw's frame is flush against
the stand and that all the stand legs are touching the
ground.
 Install leg stand bolts through the holes in the brackets
and frame. Secure with wing nuts and tighten securely.
 Be sure the table saw is on level ground and the stand is
sturdy before use.
INSIDE LEG
ASSEMBLY
15 - English
HEX
NUT
OUTSIDE LEG
ASSEMBLY
WING
NUT
LEG
STAND
BOLTS
STAND
BOLT
Fig. 8
Fig. 9