Ryobi RTS11 Manual Del Operador página 5

workpiece through the blade instead of using your hands.
Size and shape can vary but the push stick must always
be narrower than the workpiece to prevent the push stick
from contacting the saw blade. When ripping narrow
stock, always use a push stick, or the jig mentioned in the
How to Make A Jig (For Rip Cutting Narrow Workpiece)
section of this manual, so your hand does not come close
to the saw blade. Use a featherboard and push blocks
for non-through cuts.
 WHEN MAKING NON-THROUGH RIP CUTS, always
use a push stick, push block, and/or featherboard so your
hands do not come within 3 inches of the saw blade.
 WHEN RIPPING NARROW STOCK, always use a push
stick, push block, jig ( designed for narrow ripping), or
featherboard.
 NEVER perform any operation "freehand" which means
using only your hands to support or guide the workpiece.
Always use either the rip fence or miter gauge to position
and guide the work.
 NEVER stand or have any part of your body in line with
the path of the saw blade.
 NEVER reach behind, over, or within three inches of the
blade or cutter with either hand for any reason.
 ALWAYS REMOVE THE RIP FENCE from the saw when
cross cutting.
 DO NOT USE THE MITER GAUGE AND RIP FENCE
during the same operation.
 NEVER use rip fence as cutoff gauge when cross cutting.
 NEVER attempt to free a stalled saw blade without first
turning the saw OFF and disconnecting the saw from the
power source.
 PROVIDE ADEQUATE SUPPORT to the rear and sides
of the saw table for wide or long workpieces.
 AVOID KICKBACKS (work thrown back toward you) by:
a) Keeping blade sharp.
b) Keeping rip fence parallel to the saw blade.
c) Keeping riving knife, anti-kickback pawls, and blade
guard in place and operating.
d) Not releasing the work before it is pushed all the way
past the saw blade using a push stick.
e) Not ripping work that is twisted or warped or does
not have a straight edge to guide along the fence.
SPECIFIC SAFETY RULES
5 - English
 IF THE POWER SUPPLY CORD IS DAMAGED, it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.
 AVOID AWKWARD OPERATIONS AND HAND
POSITIONS where a sudden slip could cause your hand
to move into the cutting tool.
 USE ONLY RECOMMENDED ACCESSORIES listed
in this manual or addendums. Use of accessories that
are not listed may cause the risk of personal injury.
Instructions for safe use of accessories are included with
the accessory.
 MAKE SURE THE WORK AREA HAS AMPLE LIGHTING
to see the work and that no obstructions will interfere with
safe operation BEFORE performing any work using the
table saw.
 ALWAYS TURN OFF SAW before disconnecting it, to
avoid accidental starting when reconnecting to power
supply.
 ONLY USE BLADES within the thickness range stamped
on the riving knife.
 THIS TOOL should have the following markings:
a) Wear eye protection.
b) Use saw blade guard and riving knife for every
operation for which it can be used, including all
through sawing.
c) Keep hands out of the line of saw blade.
d) Use a push stick when required.
e) Pay particular attention to instructions on reducing
risk of kickback.
f) Do not perform any operation freehand.
g) Never reach around or over the saw blade.
h) Never operate saw on floor or below waist height.
 NEVER CUT MORE THAN ONE PIECE OF MATERIAL
AT A TIME.
 SAVE THESE INSTRUCTIONS. Refer to them frequently
and use to instruct other users. If you loan someone this
tool, loan them these instructions also.